Diferencias

Muestra las diferencias entre dos versiones de la página.

--- router:gl-x750 [18:18 15/08/2024] – anakino7
+++ router:gl-x750 [20:29 19/05/2025] (actual) – editor externo 127.0.0.1
@@ Línea 44: / Línea 44: @@
 To Start vi
 To use vi on a file, type in vi filename. If the file named filename exists, then the first page (or screen) of the file will be displayed; if the file does not exist, then an empty file and screen are created into which you may enter text.
-| vi filename | edit filename starting at line 1 |
-| vi -r filename | recover filename that was being edited when system crashed |
+{{tablelayout?colwidth="129px,387px"}}
+^                  ^                                                                          ^
+|vi filename     |edit filename starting at line 1                                         |
+|vi -r filename  |recover filename that was being edited when system crashed               |
+|:x<Return>      |quit vi, writing out modified file to file named in original invocation  |
+|:q<Return>      |quit (or exit) vi                                                        |
+|:q!<Return>     |quit vi even though latest changes have not been saved for this vi call  |
+|  |  |
 To Exit vi
 Usually the new or modified file is saved when you leave vi. However, it is also possible to quit vi without saving the file.
 Note: The cursor moves to bottom of screen whenever a colon (:) is typed. This type of command is completed by hitting the <Return> (or <Enter>) key.
-*	:x<Return>	quit vi, writing out modified file to file named in original invocation
+*	:x<Return>
  	:wq<Return>	quit vi, writing out modified file to file named in original invocation
  	:q<Return>	quit (or exit) vi